DTC Fault Memory erase for VAG

  • 名稱 :DTC Fault Memory erase for VAG
  • 版本 : 4.3.0
  • 分類 :汽車與車輛
  • 系統 : 4.0 以上
  • 官網 : Home
  • 內容分級 : 3 歲以上

Google Play 下載

DTC Fault Memory erase for VAG介紹 :

DTC Fault Memory erase for VAG This Software can erase/read Volkswagen, Audi, Seat, Skoda DTC Fault memory in all ECU`s at once by OBDII.
Works with VAG cars start from year 2005 with CAN gateway.
Any third party ELM327 Bluetooth OBD adapter can be used for this.

except some models:
i.e. Skoda Fabia, VW Polo, VW Lupo to year 2009

ELM327 compatible Bluetooth adapter must be used
1. Plug ELM327 to car OBDII connector
2. Run software on your Smart phone
Wait few seconds and all errors in all electronic systems will be erased.

Some faults cannot be cleared (such as internal ECU faults) and the control module may explicitly refuse. Be aware, clearing fault Codes does not fix the problem that caused the fault! 該軟件可擦除/讀取大眾,奧迪,西亞特,由OBDII所有ECU`s一次斯柯達DTC故障存儲。
工程與VAG汽車開始從2005年的一年,CAN網關。
任何第三方ELM327藍牙OBD適配器可用於此目的。

除瞭一些型號:
即斯柯達法比亞,大眾波羅,大眾路波到2009年
 
ELM327兼容的藍牙適配器必須使用
1.將ELM327到汽車OBDII連接器
2.你的智能手機上運行的軟件
等待幾秒鐘,在所有的電子系統中的所有錯誤都將被刪除。

有些故障不能被清除(如內部ECU故障)和控制模塊可以明確地拒絕。請註意,清除故障代碼並沒有解決導致錯誤的問題!

Leave a Reply

發佈留言必須填寫的電子郵件地址不會公開。 必填欄位標示為 *